Digital Timer AZB-30 USB (Without Sensors)

Technical Specification:

- 01 display LDC 2 × 16 with backlight;
- Resolution 0,00001s (1uS);
- 2 digital inputs / outputs for connecting up to 2 photoelectric sensors;
- Polarized output connection to coil with 8,5V / 1.5A
- Memory for storage of measurements of each function;
- The on / off button;
- Button for momentary retention and coil shooting;
- Short-circuit protection;
- Power supply with switched input 110 / 220V output with low voltage of 12V / 2A with connection plug NBR 14136;
- Polycarbonate panel with display protector transparent LCD and touch type buttons;
- Mounted enclosure;
- Detection system and the sensors;
- USB connection and software for data acquisition.
- Three functions: 

• F1 [measuring the time interval between the sensors, coil and sensor and switch and sensors, set up to select the number of sensors to be used in experiment];
• F2 [Measurement interruption time of 1 sensor or both sensors or measurement time between sensors];
• F3 [measuring time by the number of sensor interrupts with the number of interrupts setting for the measuring period pendulums or swirling]; 

Data Acquisition Software AZB-30 USB

Minimum requirements:

• Windows 7, Windows 8.1, Windows 10, 32- or 64-bit
• Processor 500 MHz or higher (Windows 10 requires a 1 GHz processor)
• Minimum of 512 MB of RAM (Windows 10 needs at least 1GB for 32bit and 2GB for 64bit)
• Space for 10 MB installation
• USB port